SIKA INJECTION -101 IN सप्लायर, हैदराबाद में व्यापारी

जांच भेजें

Request To Call Back

Price 3150.0 आईएनआर/ Kilograms

मूल्य/उद्धरण प्राप्त करें

MOQ : 1 Kilograms

Trade Information

Minimum Order Quantity
1 Kilograms

आपूर्ति की क्षमता
प्रति दिन

डिलीवरी का समय
दिन

नमूना उपलब्ध
Yes

मुख्य निर्यात बाजार

About

91 000 74051 Sika Injection-101 IN is a two-component, water-reactive polyurethane resin that foams when it contacts water, forming a flexible, hydrophobic closed-cell foam. Its designed for stopping running water leaks, filling cracks and joints in concrete under hydrostatic pressureideal for foundations, tunnels, water tanks, retaining walls, basements etc.

Key Features & Benefits

Low viscosity resin for deep penetration into cracks & voids.

Produces a flexible, closed-cell foam that is hydrophobic and resists future water ingress.

Reacts with water to foam up to ~40 its original volume.

Fast gel time (~10 seconds) allowing quick sealing.

Comes pre-batched (5 kg kit: 4.5 kg base + 0.5 kg catalyst) for ease of use.

Suitable for use under hydrostatic pressure.

Q1. How is Sika Injection-101 IN applied?

Clean the crack/joint (remove loose particles, oil, wax).

Seal around the injection packer (if needed) to avoid resin escaping.

Mix Part A (base) and Part B (catalyst) at ~90:10 ratio (or adjust within allowed limits for reaction time).

Use injection pump to inject resin at low pressure, allow foam to expand and seal.

Once set, clean away excess.

Q2. What is gel time & cure time?

Gel time is about 10 seconds at ~25-30 C. Tack-free / initial curing takes ~2 hours.

Q3. What are the packaging & storage details?

Comes as a pre-batched 5.0 kg kit: 4.5 kg base (Part A) + 0.5 kg catalyst (Part B). Store in sealed, unopened containers at 5-30 C. Shelf-life ~12 months.

Q4. Is it safe for potable water or for use in drinking water tanks?

It is hydrophobic and resistant to fungi/microorganisms. But products like this are generally for structural waterproofing, not for direct contact with potable water without checking specific approvals. Always check local PDS / safety data.

Q5. What surface temperature and ambient conditions are needed?

Both ambient and substrate temperatures should be between +10 C to +40 C.

Q6. How much does it cost (rough estimate)?

Please Visit or Contact CivilizeMart अधिक Information

Tell us about your requirement